# What is the difference between Abaqus and Calculix contact input?

I'm using Abaqus/CAE to create a cup deep drawing simulation and everything worked perfectly, but my objective is to run the same exact simulation on Calculix (I am new to using this program) and compare the results.

So I used the same geometry and mesh and converted all the keywords from the input file of Abaqus to match the format of the input file for Calculix (it is a simple simulation so no big changes are made).

However, when I run the CCX solver, it stops at $$t=0.09$$ (total time is $$t=1$$) and displays the error message:

Too many cutbacks.


I tried:

• refining the mesh of the slave part
• lowering the initial time increment

I don't know where the problem is in my input, although it seems to me that is in the contact definition because every other thing defined is very simple (like mesh, boundary condition, and surface definition, etc...) and no complicated parameters are needed.

This is how I defined the contact:

** contact
*Contact Pair, Interaction=SI1, Type=Surface To Surface
Slave_tole, Master_poin
*Surface Interaction, Name=SI1
*Surface Behavior, Pressure-Overclosure=Linear
1290000
*Friction
0.25, 350000


I used the same values as in the Abaqus simulation.