0
$\begingroup$

I have installed openFoam on Debian GNU/Linux and learning from official user guide. I have a problem with generating streamlines. I am trying to generate streamlines as explained in the post processing section (look at 2.1.4.5 Streamline plots).

The configuration setup explained is as follows:

enter image description here

And the expected output is:

image2

But I am getting out put as follows (click on image to zoom):

enter image description here

Any idea what I am missing?

[Upto this step all things run fine: meshing, icoFoam, contours, Vector plots etc.]

$\endgroup$
6
  • $\begingroup$ This question seem more appropriate to Paraview's Q&A. $\endgroup$
    – nicoguaro
    Jul 13, 2020 at 13:58
  • $\begingroup$ @nicoguaro which site? $\endgroup$
    – Pandya
    Jul 13, 2020 at 16:56
  • $\begingroup$ This is the Q&A for ParaView: discourse.paraview.org $\endgroup$
    – nicoguaro
    Jul 13, 2020 at 17:06
  • $\begingroup$ @nicoguaro ok. Thanks. I'll refer it. Should I delete my question if it's off-topic here? $\endgroup$
    – Pandya
    Jul 13, 2020 at 17:07
  • $\begingroup$ That's an option. Or I could close it, so the answer is kept. $\endgroup$
    – nicoguaro
    Jul 13, 2020 at 17:09

1 Answer 1

1
$\begingroup$

Your initial and end points for the line are the same, thus you only have one line that "emanates" from it. To have multiple streamlines you need multiple seed points. You need to have a vertical line that spans your domain to obtain something similar to what you want.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.